Article 3U.K.
Directive 70/156/EEC is amended as follows:
Annex I is amended as follows:
the following line is added to point 0.5:
‘Name and address of authorised representative, if any:’
the following point is inserted:
‘12.7.Table of installation and use of RF transmitters in the vehicle(s), if applicable (see Annex I, 3.1.8.):
frequency bands (Hz) | max. output power (W) | antenna position at vehicle, specific conditions for installation and/or use |
---|
The applicant for type-approval must also supply, where appropriate:
Appendix 1
A list (with make(s) and type(s) of all electrical and/or electronic components concerned by this Directive (see points 2.1.9 and 2.1.10) and not previously listed.
Appendix 2
Schematics or drawing of the general arrangement of electrical and/or electronic components (concerned by this Directive) and the general wiring harness arrangement.
Appendix 3
Description of vehicle chosen to represent the type
Body style:
Left or right hand drive:
Wheelbase:
Appendix 4
Relevant test report(s) supplied by the manufacturer or approved/recognised laboratories for the purpose of drawing up the type-approval certificate.’
In Annex III, Section A, the following line is added to point 0.5:
‘Name and address of authorised representative, if any:’.